PRATT & LAMBERT PAINTS The Quality Advantage... in Architectural Finishes Since 1849 PRODUCT INFORMATION Direct-To-Metal High Build Phenolic Urethane (S24-line) D-T-M Phenolic Urethane is a single-package, high build coating formulated by combining Phenolic and urethane resins. The Phenolic provides a very chemical resistant product and the urethane gives it toughness with excellent gloss retention. D-T-M Phenolic Urethane is fortified with corrosion inhibitive pigments and durable non-fading colors that make this product excellent for resistance to corrosion from acids, alkalies, salts and a variety of chemicals. Its ability to be applied directly to properly prepared ferrous metal eliminates the necessity for a prime coat. D-T-M Phenolic Urethane can be used inside and outside fertilizer equipment, tanks, spreaders, hoppers, dump bed bodies, refuse compactors, metal buildings, workmen end materiel hoists, above and belong ground mining equipment and metal substrate where chemicals,dirt and moisture can cause rust and corrosion. Chemical Resistance: Acids - excellent Alkalies - excellent Solvents - fair Salts - excellent Water @ 77°F - excellent Water @ 150°F - excellent Temperature Resistance: 250°F continuously; 350°F intermittently Flexibility: excellent Weathering: excellent Ordering: Available in 1 gallon containers. Five gallon containersavailable by special order only. TECHNICAL DATA TYPE: Urethane Phenolic Modified Alkyd COMPONENTS: one COLORS: Soft White, Black, Gray and safety colors. GLOSS: 85 minimum @ 60° FLASH POINT: In excess of 50°F (10°C). Black below 50°F(10°C). SOLIDS BY VOLUME: 50.0% +/- 3% VOC: maximum 3.5 Ibs/gal (420 g/1) RECOMMENDED FILM THICKNESS: 3.5 - 4 mils dry SPREADING RATE: 750 square feet per gallon at 1 mil dry film thickness (approximately 190 square feet per gallon at 4 mils dry film). SURFACE PREPARATION: Surface must be free of dirt, grease and loose rust or loose mill scale. Performs well over surfaces cleaned in accordance with SSPC-SP 3, Power Tool Cleaning. MIXING: Stir thoroughly prior to application. POTLIFE: n/a SHELF LIFE: 1 year APPLICATION: Brush,dip, roll or spray. DRYING TIME @ 77°F(25°C): Set to touch 1 hr. Tack free 6-10 hrs. PRIMER: Any P&L alkyd primer or may be self-priming. THINNING: No reduction for brush, roller or airless spray. CLEANUP: Thinner S6684 (xylene)   FOR PROFESSIONAL USE ONLY Pratt & Lambert, Inc. "Technical services, advice, and recommendations are rendered free. They are based on technical data which we believe to be reliable and are intended for use by persons having skill and know how, at their own discretion and risk We assume no responsibility for results obtained or damages incurred from their use by the Buyer in whole or in part "   Pratt & Lambert Industrial Product Index SPECTRA PAINT CENTERS HOME Electronic Mail: mail@spectrapaint.com Copyright © 1999 Spectra Paint Centers All rights reserved.